The site is known as the old Cuddeback Mill that was initially constructed as a green veneer operation and remained so until the early 1990s. In 2004, QWEST (now Lumen Technologies) refurbished and built what is currently on site. The buildings and structures are in excellent condition, and the site is ready for the following user. The property consists of the following: WAREHOUSE/STORAGE AREA - approximately 59,000 SF total with an approximate 52,844 SF being usable (the rest has buildings in it). The building has a concrete floor, 24’ minimum beam height, 208/220-volt power single phase 600 amp service, sprinkler system, LED lighting throughout, and drive-thru access. OFFICE BUILDING - The office building is the original office for Cuddeback Lumber. It has been upgraded with offices upstairs and down, a garage and storage area that connects to the office building, a janitor closet, and a data room with a T1 line. The office is approximately 9,400 SF, consisting of 5,850 SF on the ground floor and 3,550 SF upstairs. VEHICLE REPAIR SHOP - Located in the warehouse, the vehicle repair shop is a clean working shop with lifts and hoses ready for use. It is a two-bay drive-thru service shop, CMU block structure with a roof. The building has office/storage areas and restrooms, which comprise 4,104 SF with an approximate 1,650 SF mezzanine storage area. It is equipped with 208/220-volt electrical power single phase 600 amp service. It comes with a hoist system and lube system. CREW BUILDING - This building sits under the large warehouse next to the vehicle repair shop. This building is approximately a 2,052 SF CMU block building used for parts and crew. It is air-conditioned and has a restroom. It is an open floor plan that can house a variety of uses.